The appliance shall be connected to earthed socket. Verify that main voltage is in accordance with voltage of appliance. Note! Permanent fixed installation must be done by authorized electrician.

Connect plug to wall socket. Putting Digi-Line in operation by connect main cable to main voltage. Put the radiator in operation by pressing the master = switch 0/1. Status signal: Radiator IS HEATING = red LED diode is shining. Radiator IS NOT HEATING = red LED diode is not shining. Please set your appliance to wished functions by reading and using the DIGI LINE IHS MANUAL. Please note! The thermostat is air-controlled - it reacts on temperature of surrounding air. Under usage, please make sure that the power cable not get in contact with the heating parts. Please hold in the plug not in the cable when it shall be pulled out from the wall socket.

Please read and take part and use the DIGI LINE IHS MANUAL to set functions and understand it's unique possibilities to reach a more economic usage.

Please note!!! that the wall holders shall be mounted so the radiator has minimum distance to floor 60 mm, and 100 mm to the windowsill and 100 mm to corners. The Radiator can not be mounted direct under permanent wall sockets. Control that the radiator is mounted horizontal and that the display are placed in the top corner of the radiator.

The wall holders are spring based snap holders. Mount first of all the wall holders on the wall. [A] Pull up the snap holders so they get caught in the over position. [B] Place the appliance in the sidetrack acc. to picture 3.b [C] Press the snap holder backwards and the snap holder falls back in track. [D] Acc. to picture 3 d. shall it look when you mounted the wall holders correctly.

The radiator is provided with an mechanically restore protection against overheating. The overheat protection falls out automatically if the radiator get overheated. By reset, put the main switch on position off [0]. When the heater has cooled put the radiator in operation again with main switch on [1].

Do not use the appliance in imminent proximity of bath tub, shower, swimming pool or such. The appliance must not be installed in such way that the person using any of above facilities also may be in contact with the appliance.

For the thermostat to function correctly it must not be covered.

Wipe clean with moist cloth if need. Note: do not use wet cloth. Disconnect the appliance before cleaning.

b. Verify fuses and that the plug is properly connected to socket. Set thermostat to max.

If appliance still does not work, contact seller . Please note! This appliance is filled with an exact quantity of thermodynamic fluid, why reparations with result in that the appliance must be opened, can this only be done by the producer or it's representatives. Oil leakage must be report to producer or it's representatives.